Gas Fireplace Parts

Gas Fireplace Parts:Boldly decorated, streamlined, minimalist, which of these fireplaces do you want to make your sweet home?

Product Details

Gas Fireplace Parts

Wall hanging furnace is the core component of the four major systems of floor heating. The selection of wall hanging furnace with appropriate power can not only reduce the heating cost, but also improve the quality of life. The following major factors should be considered when selecting the wall hanging gas furnace:

1. Local climatic conditions: the average temperature in local winter is very important for the selection of wall hanging furnace.The winter indoor temperature value that the country sets is certain, because this winter average temperature is low area, heat power of wall hanging furnace can choose a few higher;In areas with high average temperature, the thermal power of the wall furnace can be selected to be lower.

2. Thermal insulation of buildings in the south and north, especially in terms of thermal insulation, there is a big gap between them. The south has a hot and rainy weather.From the building thermal insulation performance analysis, the south of the building as a whole than the north, at this time the role of heating insulation board is more important.

3. The area of the house is larger, and the thermal efficiency of the wall hanging furnace should be larger;And vice versa.In general, the output power is 18KW for less than 80 square meters, 24KW for 120 square meters, 28KW for 160 square meters,36KW for 220 square meters, and so on. The larger the power, the larger the area, the higher the yield rate of hot water.If it is a large house to choose small power, the general wall furnace will cause room temperature is not high;And if it is a small house to choose high power, will cause gas waste.The location of the four houses is the same building, with different floors and orientations, and different requirements for heat load.The first floor of the building and the insulation of the top floor is relatively poor, up and down around the middle position insulation is the best.These factors should be fully considered in the selection of wall hanging furnace.

Gas fireplace part of the main introduction:


Gas Fireplace Parts


We offer customization in size, color, and design. 


Over 30-year factory experience


Outer in 3cm standard wooden crate, inner in plastic or foam

Arrival time

40-60 days after deposit (15-20days to produce, 25-35days to transport)


High polished or honed


We can take orders according to photo or drawing from you

Quality Standard

1.Strict Quality Control and Supervision System Guarantees Good Quality.
2.First Inspection: Select A Grade raw material.
3.Second Inspection: Monitoring the whole process.
4.Third Inspection: Checking pieces by pieces, Color Difference Control.
5.Well packed to prevent damage during long distance transportation.

Main picture of gas fireplace part of the product: